[Matt Evans] was running up against the common programming gotcha caused by disappearing parallel ports. For years he had used a JTAG parallel cable when working with FPGAs but recently realized ...

But then what? He needed a JTAG programmer to work with the chip. Like any good autodidact he choose to make his own rather than buying one. He absorbed the JTAG specification and coded a bit ...

The MAXQUSBJTAG-KIT is a USB-to-JTAG interface board offered by Maxim for this purpose ... user interface, and flash programmer Example program code and typical application firmware A fully tested ...

I'm planning to develop a design using the TMS320F28069F processor and I'm looking at how I should go about debugging and programming it with JTAG. As this will just be a prototype, I'd like to use ...

The Digilent JTAG uses FTDI chips, but its configuration EEPROM contains data needed to be recoginzed by Xilinx ISE/Vivado. For patch dongle you will need GNU Linux, but the patched FT232H doggle also ...

You can use this module as a high-speed programmer for your embedded projects. I discovered that this module can be used as a JTAG and SWD programmer for ESP32 and STM32 microcontrollers. It can also ...