If you want to use the interrupt pin, the pulses generated by the ADS1115 might be to short to be properly recognized in the software, i.e. on a MCU. The schematic below shows a way of increasing the ...

In general, I think that the ADS1115 is capable of making good measurements near ground, and should easily make shunt resistor measurements. Are you able to share a schematic? Even a simplified ...

We use ADS1115 to sample the Voltage and Current signal ... PLS help on this. It's not very clear in the schematic you provided, so can you confirm that the op-amps are configured as unity gain ...

Schematics are roughly based on the Juno 106 ... Voltage control comes from a ADS1115 16-bit ADC and ranges from 0-10V. There is also a design based on the Raspberry Pi Pico which is even more precise ...