While there are a couple of open-source brushless drivers already available, [neuromancer2701] created his own brushless motor controller on an Arduino shield. [neuromancer2701]’s shield is a ...

This code is for testing the motor control on the official shield from Arduino. This can control two motors in both directions at the same time. There are a total of ...

If you are using the W5100 ethernet shield, then pin 10 should be bent or cut off and wire should be connected from pin 10 on the Ethernet shield to pin 53 of the Arduino Mega. ***This setup is not ...

The short version of the story is that he cuts out the original control board and wires the three motors up to an Arduino Motor Driver Shield, and when combined with the appropriate code ...